Product Overview
A precision alumina ceramic tube is specified when the bore, the outer diameter, and the straightness all have to sit inside a defined tolerance for the tube to assemble correctly. It is installed in vacuum equipment, precision instruments, electronic devices, and high-accuracy sensor assemblies. Standard ceramic tube tolerances are not tight enough for these positions, which is what separates this product from a general-purpose alumina tube.
What "Precision" Means in Numbers
|
Item |
Value |
|
Material |
99% alumina |
|
Inner diameter |
2–80 mm |
|
Outer diameter |
5–120 mm |
|
Length |
10–500 mm |
|
Dimensional tolerance |
±0.02 mm (machined) |
|
Bore roughness |
Ra ≤ 0.8 μm |
|
Straightness |
≤ 0.1 mm/100 mm |
These figures are the ones that decide whether the tube fits. The bore tolerance of ±0.02 mm is held after finish grinding, not as-fired. Bore roughness of Ra ≤ 0.8 μm is measured on the finished bore. Straightness of ≤ 0.1 mm per 100 mm is what keeps a long tube from binding when it is inserted into a housing.
How the Tolerance Is Held
The tube is formed by dry pressing or isostatic pressing and fired, then the bore and the outer diameter are finished by CNC grinding. The grinding step is what moves the part from the as-fired tolerance to the ±0.02 mm figure. Because the grinding happens after sintering, the final dimensions do not depend on shrinkage compensation alone.
Wall thickness matters at this tolerance level. A thin-wall tube is more likely to deform during sintering and during grinding, so the wall thickness to bore ratio is reviewed before the tolerance is confirmed. If the ratio is outside what the process can hold, we say so before quoting rather than after.
What to Send
Provide the drawing with inner diameter, outer diameter, wall thickness, length, and end-face geometry. State which dimensions are critical for the assembly and what tolerance is required on each. If the bore has a special finish or tolerance requirement, note it on the drawing so the grinding route can be assessed.
Applications
Precision insulating tubes for vacuum equipment
01
Insulating support tubes for precision instruments
02
Insulating bushings for electronic devices
03
Insulating tubes for high-accuracy sensors
04
FAQ
Q: What bore tolerance can be held after finish grinding?
A: The bore tolerance is typically held within ±0.02 mm after finish grinding. The achievable figure depends on the bore size and the length-to-diameter ratio, because a long, small-bore tube is harder to hold than a short one. Provide the drawing and we will confirm the tolerance for that specific size.
Q: Can you produce thin-wall precision tubes?
A: Thin-wall tubes can be produced, but they are more likely to deform during sintering and grinding. There is a limit to the wall thickness to bore ratio, and the ratio is reviewed before the tolerance is confirmed. Provide the specific dimensions and the wall thickness will be assessed for feasibility.
Hot Tags: precision alumina ceramic tube, China precision alumina ceramic tube manufacturers, suppliers, factory, Alumina Ceramic Tube, Alumina Tube, ceramic tube, High Temperature Ceramic Tube







