Steatite Ceramic Insulators

Steatite Ceramic Insulators
Details:
A steatite ceramic insulator sits between alumina and plastic on both cost and performance. Alumina insulates well but costs more; plastic is cheap but cannot take heat. Steatite covers the middle: dielectric constant of 6–7, dissipation factor of (3–20) × 10⁻⁴, dielectric strength of 20–30 kV/mm, at a raw material cost well below alumina. It is used in high-frequency equipment, household appliances, small motors, lighting equipment, and coil formers.
Send Inquiry
Download
Description
Technical Parameters

Product Overview

A steatite ceramic insulator sits between alumina and plastic on both cost and performance. Alumina insulates well but costs more; plastic is cheap but cannot take heat. Steatite covers the middle: dielectric constant of 6–7, dissipation factor of (3–20) × 10⁻⁴, dielectric strength of 20–30 kV/mm, at a raw material cost well below alumina. It is used in high-frequency equipment, household appliances, small motors, lighting equipment, and coil formers.

 

The Sintering Window Problem

Steatite has a narrow sintering range of about ±10°C. If the firing curve drifts outside that window, the body can develop aging cracks that do not show up until the part is in service. This is the single most common failure mode for steatite, and it is why some suppliers avoid the material.

 

The raw material is pre-fired before batching. Pre-firing breaks down the layered structure of the talc, which prevents the directional alignment that would otherwise occur during forming. The body is then ground, blended, and fired under a controlled curve. The result is a denser body and more consistent dimensions across the batch.

 

Electrical and Mechanical Data

Item

Value

Material

Steatite (MgO·SiO₂)

Dielectric constant

6–7

Dissipation factor

(3–20) × 10⁻⁴

Dielectric strength

20–30 kV/mm

Volume resistivity

10¹²–10¹⁴ Ω·cm

Operating temperature

≤ 1100°C

Flexural strength

≥ 126 MPa

Shape

Round / square / profiled (per drawing)

The dissipation factor is the figure that matters in high-frequency applications, because it determines how much energy the insulator absorbs rather than passes. The flexural strength figure is the one to check where the part carries a mechanical load in addition to insulating.

 

Where It Fits

High-frequency equipment insulating components

01

 

Household appliance insulating parts

02

Small motor insulation

03

Lighting equipment insulating components

04

Coil formers and insulating tubes

05

 

FAQ

Q: How does the steatite ceramic insulators material compare with alumina on dielectric loss?

A: Steatite has a lower dielectric constant (6–7) and a dissipation factor of (3–20) × 10⁻⁴, which suits high-frequency circuits. Alumina has a higher dielectric constant (9–10) but withstands higher temperatures, up to 1400°C and above. If the application is frequency-sensitive, steatite is the lower-loss option; if it is temperature-sensitive, alumina is the correct choice.

Q: Can you adjust the firing curve for different wall thicknesses?

A: Yes. Different wall thicknesses require different firing curves to avoid deformation and cracking. The curve is set per product rather than applied as a single standard profile.

 

 

Hot Tags: steatite ceramic insulators, China steatite ceramic insulators manufacturers, suppliers, factory, ceramic electrical connection components, Ceramic Protection Tube, Ceramic Sheath Tube, Ceramic Thermocouple Protection Tubes, Ceramic Thermocouple Sheath, electronic ceramics

Send Inquiry