Machinable Ceramic Components

Machinable Ceramic Components
Details:
A machinable ceramic component is a ceramic part that can still be cut after firing. Standard ceramics are so hard after sintering that turning, milling, and drilling are slow and expensive, and for complex or high-accuracy parts the machining cost can exceed the material cost. Machinable ceramic components use a mica-based or glass-phase ceramic that retains some machinability after firing, so standard carbide tooling can be used for turning, milling, and drilling.
Send Inquiry
Download
Description
Technical Parameters

Product Overview

A machinable ceramic component is a ceramic part that can still be cut after firing. Standard ceramics are so hard after sintering that turning, milling, and drilling are slow and expensive, and for complex or high-accuracy parts the machining cost can exceed the material cost. Machinable ceramic components use a mica-based or glass-phase ceramic that retains some machinability after firing, so standard carbide tooling can be used for turning, milling, and drilling.

 

Where the Cost Advantage Shows

For small batches, multiple variants, and complex insulating or structural parts, the machining cost is what drives the price. A machinable ceramic component can be produced with standard tooling rather than diamond grinding, which lowers the cost of complex geometry. For R&D samples, the flexibility matters more than the per-part cost: a design can be tested in ceramic quickly without waiting for a custom mold or a sintering-specific forming route.

 

The insulation properties are still ceramic: high volume resistivity, low dielectric loss, and the temperature resistance, corrosion resistance, and wear resistance of a ceramic body.

 

Item

Value

Material

Machinable ceramic (mica-based / glass-phase)

Machining method

CNC turning / milling / drilling

Operating temperature

≤ 1000°C (by material)

Volume resistivity

> 10¹² Ω·cm

Dimensional tolerance

±0.05 mm (tighter available)

Minimum wall thickness

1 mm (by geometry)

 

Strength versus Dense Ceramics

Machinable ceramic contains mica or a glass phase, so its mechanical strength is lower than 95% or 99% alumina. It is suited to insulating supports and structural isolation where the mechanical load is not extreme. Where strength is the governing requirement, alumina is the correct material and the higher machining cost has to be accepted. The two are not interchangeable on strength.

 

Size Range

The maximum part size is limited by the CNC equipment travel. Parts up to 300 mm in diameter are produced as standard, and larger sizes are assessed per drawing.

 

Applications

Functional verification parts for R&D

01

 

Complex-geometry insulating components

02

Small-batch custom ceramic parts

03

Replacement ceramic parts for equipment maintenance

04

 

FAQ

Q: How much weaker is machinable ceramic than dense alumina?

A: Machinable ceramic contains a mica or glass phase, so its mechanical strength is below that of 95% or 99% alumina. It is suited to insulating supports and structural isolation where the load is moderate. Where strength is the governing requirement, alumina is the correct material.

Q: What is the largest part you can machine?

A: The limit is set by the CNC equipment travel. Parts up to 300 mm in diameter are produced as standard. Larger parts are assessed per drawing.

 

 

Hot Tags: machinable ceramic components, China machinable ceramic components manufacturers, suppliers, factory, ceramic electrical connection components, Ceramic Protection Tube, Ceramic Thermocouple Protection Tubes, Ceramic Thermocouple Sheath, electronic ceramics, G9 Ceramic Lamp Holder

Send Inquiry